Please select and order
€143.05
excl. VAT
Add to cart
Norm

ÖNORM EN 1286

Issue date: 1999 07 01

Sanitary tapware - Low pressure mechanical mixing valves - General technical specification

This European Standard specifies requirements for low hydraulic resistance mechanical mixing valves suitable for use in low pressure water suppl y s ystems as described ...
Valid
§ Legal References
Publisher:
Austrian Standards International
Format:
Digital | 54 Pages
Language:
German | English | Download GER/ENG
Optionally co-design standards:
This European Standard specifies requirements for low hydraulic resistance mechanical mixing valves suitable for use in low pressure water suppl y s ystems as described in informative Annex C. This European Standard specifies : - the dimensional, leaktightness, mechanical and hydraulic performance, mechanical endurance characteristics with which low pressure mechanical mixing valves shall comply ; - the procedure for test ing these characteristics. It is applicable : to low pressure mechanical mixing valves, intended for use on sanitary appliances in washrooms (toilets, bathrooms etc.) and in kitchens ; to low pressure mechanical mixing valves used under the following pressure and temperature conditions given in table 1.
ÖNORM EN 1286
1999 07 01
Sanitary tapware - Low pressure mechanical mixing valves - General technical specification
Norm
Norm
ISO 228-1:2000
Issue date : 2000 09 21
Pipe threads where pressure-tight joints are not made on the threads — Part 1: Dimensions, tolerances and designation
Norm
ÖNORM EN 111
Issue date : 2003 06 01
Wall-hung hand rinse basins - Connecting dimensions
Norm
ÖNORM EN 1254-2
Issue date : 1998 04 01
Copper and copper alloys - Plumbing fittings - Part 2: Fittings with compression ends for use with copper tubes
Norm
ÖNORM EN 1254-2
Issue date : 2007 08 01
Copper and copper alloys - Plumbing fittings - Part 2: Fittings with compression ends for use with copper tubes
Norm
ÖNORM EN 1717
Issue date : 2008 04 01
Protection against pollution of potable water in water installations and general requirements of devices to prevent pollution by backflow
Norm
ÖNORM EN 232
Issue date : 2003 08 01
Baths - Connecting dimensions
Norm
ÖNORM EN 246
Issue date : 2003 12 01
Sanitary tapware - General specifications for flow rate regulators
Norm
ÖNORM EN 248
Issue date : 2003 02 01
Sanitary tapware - General specification for electrodeposited coatings of Ni-Cr
Norm
ÖNORM EN 31
Issue date : 1999 02 01
Pedestal wash basins - Connecting dimensions
Norm
ÖNORM EN 31
Issue date : 2009 02 15
Wash basins - Connecting dimensions
Norm
ÖNORM EN 32
Issue date : 1999 03 01
Wall-hung wash basins - Connecting dimensions
Norm
ÖNORM EN 35
Issue date : 2000 04 01
Pedestal bidets with over-rim supply - Connecting dimensions
Norm
ÖNORM EN 36
Issue date : 1999 02 01
Wall-hung bidets with over-rim supply - Connecting dimensions
Norm
ÖNORM EN 695
Issue date : 2005 10 01
Kitchen sinks - Connecting dimensions
Norm
ÖNORM EN 817
Issue date : 2008 12 01
Sanitary tapware - Mechanical mixers (PN 10) - General technical specifications
Norm
ISO 5167-1:1991
Issue date : 1991 12 12
Measurement of fluid flow by means of pressure differential devices — Part 1: Orifice plates, nozzles and Venturi tubes inserted in circular cross-section conduits running full