Jetzt auswählen und bestellen
120,67 €
exkl. USt.
In den Warenkorb
Norm

ÖNORM EN 9103

Ausgabedatum: 2024 05 15

Aerospace series - Quality management systems - Variation management of key characteristics

This document is primarily intended to apply to new parts and products intended to be produced in an on-going production phase but can also be applied to parts currently ...
Gültig
This document is primarily intended to apply to new parts and products intended to be produced in an on-going production phase but can also be applied to parts currently in production (e.g. manufacturing, maintenance). This document is applicable to all production processes that influence the variation of KCs, as well as maintenance and service processes in which KCs are identified. It applies to organizations for assemblies and all levels of parts within an assembly, down to the basic materials including castings and forgings, and to organizations that are responsible for producing the design characteristics of the product. The variation control process begins with product definition, typically stated in the design documentation (e.g. digital model, engineering drawing, specification) which identifies KCs, and leads to a variation management process for those KCs. This process may also be used for producer-identified KCs (e.g. process KCs, additional/substitute product KCs). Producers and their subcontractors are responsible for flow down of the standard requirements to those external providers, who produce design characteristics and provide production and service provisions, to ensure that KCs conform to the customer’s requirements. This document is designed to drive the improvement of manufacturing and maintenance processes through adequate planning and effective management of KC variation. This focus is intended to improve uniformity (less variation or minimum variation of product KCs) and acceptance probability of the end product. The following conventions are used in this document: - “shall” indicates a requirement; - “should” indicates a recommendation; - “may” indicates a permission; - “can” indicates a possibility or a capability.
ÖNORM EN 9103
2024 05 15
Aerospace series - Quality management systems - Variation management of key characteristics
Norm
ÖNORM EN 9103
2016 02 01
Luft- und Raumfahrt - Qualitätsmanagementsystems - Management der Veränderung der Haupteigenshaften ...
Norm
ÖNORM EN 9103
2015 07 01
Aerospace series - Quality management systems - Variation management of key characteristics
Norm
ÖNORM EN 9103
2006 06 01
Luft- und Raumfahrt - Qualitätsmanagementsysteme - Änderungsmanagement der Schlüsselmerkmale
Norm
Historie aufklappen
Norm
ISO 3534-2:2006
Ausgabedatum : 2006 09 29
Statistics — Vocabulary and symbols — Part 2: Applied statistics
Norm
ISO 9000:2015
Ausgabedatum : 2015 09 22
Quality management systems — Fundamentals and vocabulary
Norm
ISO 22514-7:2021
Ausgabedatum : 2021 08 25
Statistical methods in process management — Capability and performance — Part 7: Capability of measurement processes