Jetzt auswählen und bestellen
85,85 €
exkl. USt.
In den Warenkorb
Norm

ISO 8533:2019

Ausgabedatum: 2019 08 02

Glass-reinforced thermosetting plastics (GRP) pipes and fittings — Test methods to prove the design of cemented or wrapped joints

This document specifies methods of test for cemented or wrapped joints for buried and above ground glass-reinforced thermosetting plastics (GRP) piping systems. This docu...
Gültig
Herausgeber:
International Organization for Standardization
Format:
Digital | 15 Seiten
Sprache:
Englisch

This document specifies methods of test for cemented or wrapped joints for buried and above ground glass-reinforced thermosetting plastics (GRP) piping systems. This document is only applicable to the joint and covers methods of test to prove its design. It assumes that the joint either is or is not intended to be subject to the effects of hydrostatic end thrust.

The tests detailed in 9.2, 9.4 to 9.6 inclusive are applicable to cemented or wrapped joints intended to be used in buried or above-ground applications. The bending tests detailed in 9.3 can be used to prove the design where joints are either intended to be used in buried applications or are intended to be used in particular above-ground situations where the tests may be considered appropriate.

With the exception of procedure detailed in 9.3, these test procedures are applicable to joints for pipes and fittings of all nominal sizes. The tests detailed in 9.3 are applicable to joints for pipes and fittings up to and including DN 600. The tests are applicable for evaluating joints intended for applications conveying liquids at temperatures specified in the referring standards.

The test procedures in this document are damaging to the test piece, which will not be suitable for reuse after these tests. The test procedure is applied for type testing purposes only.

This document is applicable only to the joint and specifies methods of test to prove its design.

ISO 8533:2019
2019 08 02
Glass-reinforced thermosetting plastics (GRP) pipes and fittings — Test methods to prove the design ...
Norm
ISO 8533:2003/Amd 1:2012
2012 03 02
Plastics piping systems for pressure and non-pressure drainage and sewerage — Glass-reinforced therm...
Norm
ISO 8533:2003
2003 11 21
Plastics piping systems for pressure and non-pressure drainage and sewerage — Glass-reinforced therm...
Norm